topic Re: Incorrectly selected LinkerFile.ld in Kinetis Design Studio

Incorrectly selected LinkerFile.ld

michal-zajacik — Sun, 27 Jul 2014 12:46:10 GMT

Hi, when I created a new Kinetis Design Studio Project using Processor Expert configuration is always embedded in the project ProcessorExpert.ld according to the selected MCU. That is correct.

When I created a new Kinetis Design Studio Project without using Processor Expert configuration is always embedded in the project LinkerFile.ld for MKL25Z128VLH4. This is wrong.

I'm making a mistake somewhere?

Re: Incorrectly selected LinkerFile.ld

BlackNight — Sun, 27 Jul 2014 12:54:58 GMT

Hi Michal,

no, you are not doing anything wrong. This is a known issue of the beta release and is fixed in the GA release coming out the first week of August. The issue is documented in the release notes (Kinetis Design Studio V1.0.1 Beta Release Notes), section 'Project Creation', issue #1.

Erich

Re: Incorrectly selected LinkerFile.ld

michal-zajacik — Sun, 27 Jul 2014 13:10:41 GMT

Thank you, I followed the instructions and everything works well