Kinetis Design StudioのトピックProgram "make" not found in PATH...

Program "make" not found in PATH...

jacquesnapoleon — Thu, 27 Aug 2015 09:29:32 GMT

Hello,

I installed Kinetis Design Studio and download Kinetis KE02-SC.zip examples.

After importing the projects in IDE, all projects appear with problems and the error "Program "make" not found in PATH".

Could you please help...

Thanks and regards.

Re: Program "make" not found in PATH...

Alice_Yang — Fri, 28 Aug 2015 02:20:52 GMT

Hello Jacques,

Does your KE02-SC example support KDS ?

In my hand ,it only support CW ,IAR and KEIL .

Hope it helps

Alice

Re: Program "make" not found in PATH...

BlackNight — Fri, 28 Aug 2015 05:50:49 GMT

Hi Jacques,

There is a CodeWarrior project converter in KDS:

It might not be able to convert anything, but should help you getting the project to KDS.

I hope this helps,

Erich

Re: Program "make" not found in PATH...

jacquesnapoleon — Fri, 28 Aug 2015 08:04:40 GMT

Hello Alice,

Thanks for you reply.

Actually KE02-SC examples do not support KDS but these are the only available examples that can be found at KDS download web page...

Thanks again.

Jacques.

Re: Program "make" not found in PATH...

jacquesnapoleon — Fri, 28 Aug 2015 08:06:48 GMT

Hi Erich,

Thanks for your support.

I will try to convert my project file following your instructions and will let you know.

Jacques.

Re: Program "make" not found in PATH...

TICS_Fiona — Fri, 28 Aug 2015 08:10:45 GMT

Hi Jacques

The demo examples KE02-SC.zip are based on CodeWarrior, IAR and Keil. You may open or import the example project with any above IDE.

CodeWarrior v10.6.4 can be downloaded from:

http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=CW-MCU10

Or if you would import the project into KDS, please refer to this doc under your KDS folder:

C:\Freescale\KDS_3.0.0\doc\KDS_Porting_Guide.pdf

Fiona Kuang

Technical Information & Commercial Support

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------

Re: Program "make" not found in PATH...

jacquesnapoleon — Fri, 28 Aug 2015 08:17:57 GMT

Hi Fiona,

Thanks to confirm what was mentioned earlier by other people above...

Anyway, as a suggestion this could help to enhance getting started manual by including starting from scratch procedures with KDS and available examples for this IDE if any...

Thanks and regards,

Jacques.