Kinetis MicrocontrollersのトピックRe: I2C Slave Address with K60D100M

I2C Slave Address with K60D100M

valerierabon — Tue, 17 Dec 2013 16:50:00 GMT

I'm very new to this. I'm trying to build a simple code that will send a block of data to the EEPROM. Once the data is received, an LED will blink for each index of the array.

The code however does not work, and I was wondering if I have the wrong slave address (I've been using 0000011101) and/or I am missing key pieces of code.

I've included a screenshot of my code as well as the project so far.

Thank you very much!

Valerie

Original Attachment has been moved to: I2C_Test_K60.zip

Re: I2C Slave Address with K60D100M

jeremyzhou — Wed, 18 Dec 2013 08:18:58 GMT

Hi Valerie,

There were some errors when I complie your project. I also have question question want to ask you.

Which address mode did you choose? 7bit or 10bit? Becase I'm not sure based on your PE configurtion and I attach the screenshot that you can check it.

Best regards,

Ping

Re: I2C Slave Address with K60D100M

valerierabon — Wed, 18 Dec 2013 13:16:37 GMT

Hi Ping,

Thank you for taking the time to look at it. I used the 7 bit addressing mode. I've attached a screenshot of my I2C configurations.

Valerie

Re: Re: I2C Slave Address with K60D100M

jeremyzhou — Thu, 19 Dec 2013 03:08:10 GMT

Hi Valerie,

I don't have I2C demo code created by PE on hand. However I've included a I2C demo which KL25 as master control accelermeter sensor and also select 7 bit salve address mode too.

I think it should be useful for reference and I send it along with the email. Please refer to it for details.

If you have any further questions, please feel free to contact with me.

Best regards,

Ping