Kinetis MicrocontrollersのトピックRe: MKL02Z32VFM4 dump/reflash entire chip

MKL02Z32VFM4 dump/reflash entire chip

moash — Tue, 05 Nov 2024 15:45:01 GMT

iv been creating my own custom pcb that requires this chip but the ones i seem to have bought are blank/ have no bootloader on them.

My question is, is it possible to dump the bootloader from a known working chip and then mass flash onto my blanks.

If so could i get documentation/ step by step on the process.

thanks in advance

Re: MKL02Z32VFM4 dump/reflash entire chip

xiangjun_rong — Wed, 06 Nov 2024 02:33:41 GMT

Hi,

This is the website of MCU-Boot:

https://www.nxp.com/design/design-center/software/development-software/mcuxpresso-software-and-tools-/mcu-bootloader-for-nxp-microcontrollers:MCUBOOT

From the list, you can see that the KL02 does not have ROM flashloader, but KL03 has the ROM flashloader. Pls check if you replace with KL03 if you require ROM flashloader.

BTW, there is Kinetis MCU programming service, pls go to the website:

https://www.nxp.com/design/design-center/software/development-software/mcuxpresso-software-and-tools-/mcu-programming:MCU_PROGRAMMING_CENTER

Hope it can help you

Xiangjun Rong

Re: MKL02Z32VFM4 dump/reflash entire chip

moash — Wed, 06 Nov 2024 10:57:41 GMT

https://www.pjrc.com/store/ic_mkl02_t4.html

the top chip is the one i was supposed to get i suppose, i assume there is no way for me to rip what i need off of this to then mass flash on to my own ?

thanks again for the reply