Kinetis MicrocontrollersのトピックRe: Moving application location in memory

Moving application location in memory

pbaierlac — Wed, 31 Aug 2022 14:29:56 GMT

I am using the MK10DX256. I am trying to move my application to address 0x2000 so that the bootloader will reside in 0x0000 - 0x1FFF.

When I attempt to debug my application it immediately faults.

Here is my memory setup:

In my main() I set SCB->VTOR = to 0x2000. It does not appear my code is ever reaching the main() function.

If I move my application back to address 0x0000 I have no issues and it runs normally. Any assistance would be greatly appreciated.

Re: Moving application location in memory

Robin_Shen — Tue, 06 Sep 2022 07:27:45 GMT

Hi pbaierlac,

Please refer to the discussion in How to debug bootloader and application codes together in MCUXpresso

Hope it helps.

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: Moving application location in memory

pbaierlac — Sat, 21 Jan 2023 15:08:01 GMT

Thank for the help! This did correct my issue. It would be nice to just debug the application regardless of location like we could in code warrior.

Re: Moving application location in memory

alvamiler — Mon, 19 Jun 2023 07:10:31 GMT

How do I use IAR to put the rbf file in the stated address of flash?