topic Re: K10_50 debug with MCU-Link(base model) in Kinetis Microcontrollers

K10_50 debug with MCU-Link(base model)

audinus — Fri, 16 Dec 2022 10:42:06 GMT

Hello,

I am trying to debug?MK10DN32VFM5 device with the following development environment;
- KDS 3.2.0 (the only tool that support K10_50 devices as far as I know)
- MCU-Link (base model)

Well, K10_50 page tells MCU-Link(base) support the device, but the MCU-Link page does not has it in the supporting device list.(U-Multilink debugger page has it in the list ! )
So, I tried as below:
1. installed the latest MCU-Link driver (MCU-LINK_installer_2.263) -> updated the MCU-Link to CMSIS-DAP compliant
2. the original openocd does not recognize the MCU-Link, so I used?xpack-openocd-0.10.0-15
3. I used the following configuration script attached

It was not successful and the result log is attached too.

Is there anyone who could debug K10_50 device with MCU-Link(base model) ?

Any advice will be appreciated,

Thank you in advance.

#K10_50 #KDS #MCU-Link

Re: K10_50 debug with MCU-Link(base model)

Miguel04 — Mon, 19 Dec 2022 16:17:20 GMT

Hi @audinus

I suggest you to use codewarrior instead of KDS and switching to the multilink debugger. This changes should let you debug your K10_50.

Let me know if you have any other question.

Best Regards, Miguel.

Re: K10_50 debug with MCU-Link(base model)

audinus — Wed, 21 Dec 2022 07:47:26 GMT

Thank you, Miguel,

I could successfully debug my K10_50 board with KDS & u-multilink debugger.

I hope that NXP clearly show the compatible debugger in the product page.

Best regards,

Tae-Han

Re: K10_50 debug with MCU-Link(base model)

Miguel04 — Wed, 21 Dec 2022 16:19:44 GMT

Hi @audinus

I'm glad you were able to debug the board, thanks for the clarification, i'll look into it.

Best regards, Miguel.