topic Unable to connect to MK60FX512. in Kinetis Microcontrollers

Unable to connect to MK60FX512.

endzzang8 — Mon, 02 May 2022 15:38:53 GMT

I am using MK60FX512.
At some point, the connection is not working.

Verified that reset-b pin is low.

So I thought it was a lock, Initialization attempted.

"Kinetis Design Studio 3 IDE" , " J-LINK " , " Uvision5 "

But it doesn't erase.

Is there a way to erase the device?

KakaoTalk_20220503_001451015.jpg

비전_접속불가1.png

비전_접속불가2.png

비전접속불가3.png

키네스디자인접속불가-1.png

제이링크접속불가-1.png

J-LINK COMM접속불가1.png

Re: Unable to connect to MK60FX512.

ErichStyger — Mon, 02 May 2022 16:11:02 GMT

It looks you did the right thing with the J-Link, or tried the obvious things. On top of this: there is the 'resurrect' action in the NXP MCUXpresso IDE starting from v10.2.0 on, see https://mcuoneclipse.com/2018/05/20/overview-of-mcuxpresso-ide-v10-2-0/

I had cases where the device ended out of reset very fast in a non-responsive mode (like if you enter low power modes or un-muxed the SWD/JTAG pins), and the J-Link was not able to get hold of the MCU . What helped me in those cases was using the P&E Universal Multilink instead, see

https://mcuoneclipse.com/2021/05/20/recovering-cortex-m-microcontroller-with-a-power-glitch/

You might try to power cycle your MCU the same way and get a chance to get hold of the MCU with the J-Link too, but that might take some time.

I hope this helps,

Erich

Re: Unable to connect to MK60FX512.

endzzang8 — Thu, 12 May 2022 18:47:04 GMT

I tried it after purchasing it
The result was the same

111.png

2222.png

11.png

333.png