PEMicro Debugger

MichaelBMiner — Thu, 25 Nov 2021 17:38:05 GMT

Hello All,

I am using a PE Micro Multilink Universal tool with my KEA128. I have a breakpoint on a piece of code.

if(!i2c_temp_sensor_found) { WindowAverage_AddSample(&vInternal_Temp_average, ADC_GetSample()); }

The breakpoint is on the if statement. I get the warning "Not all breakpoints could be written. Continue?"

I click yes and I break on the if statement.

If I continue (F8) the code seems to go nowhere. If I press pause I am halted at the same line!

If I step into (F5) or step over (F6) I am shown an empty page _isr_vector() at 0x00 and told there is no source available. Pausing again I am at the same breakpoint. Can anyone explain what I am doing wrong with this debugger?

Re: PEMicro Debugger

jingpan — Mon, 29 Nov 2021 03:06:16 GMT

Hi @MichaelBMiner ,

KEA128 only support 2 breakpoint. If there is more breakpoints added, IDE will generate a warning and it can't execute correctly.

Regards,

Jing

Kinetis MicrocontrollersのトピックRe: PEMicro Debugger

PEMicro Debugger

Re: PEMicro Debugger