Hardwarerequirements for the MKL26Z128VLH4 SWD-Port

st165450 — Wed, 22 Apr 2020 18:47:30 GMT

Hello,

im trying to design a pcb, based on a MKL26Z128VLH4.
But i'm not sure, if there are special requirements to implement the swd port. The documentation is not very helpful at this point. My question is, if it's necessary to use a special wiring for the SWD CLK- and DIO signal.

Thanks

Falk

Re: Hardwarerequirements for the MKL26Z128VLH4 SWD-Port

kerryzhou — Thu, 23 Apr 2020 06:08:37 GMT

Hi Falk D .

About the KL series hardware design, you can refer to this document:

https://www.nxp.com/webapp/Download?colCode=KLQRUG

Chapter 2 General System Setup (Hardware Considerations)

To the SWD interface, you need to add 10K pullup in the SWD_DIO pin.

SWD interface need 5 pins: SWD_DIO, SWD_CLK, RESET, VDD, GND.

Reset pin in the MCU side should add the 4.7K to 10K pull up resistor, and 0.1uf capacitor to ground.

About the hardware wire, it is not special, just normally wire in the PCB is OK.

Wish it helps you!

If you still have questions about it, please kindly let me know.

Have a great day,

Kerry

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Kinetis MicrocontrollersのトピックRe: Hardwarerequirements for the MKL26Z128VLH4 SWD-Port

Hardwarerequirements for the MKL26Z128VLH4 SWD-Port

Re: Hardwarerequirements for the MKL26Z128VLH4 SWD-Port