Kinetis Microcontrollers中的主题 Re: I2C protocol interfacing Accelerometer MMA7660fc

I2C protocol interfacing Accelerometer MMA7660fc

mdrasool_yadwad — Fri, 20 Dec 2019 03:57:48 GMT

Hello,

I was interfacing the K60 microcontroller with the accelerometer MMA7660FC which is available on the tower board using I2C . I am configuring Microcontroller as master and MMA78451Q accelerometer as slave.

When I am transmitting in master mode the slave address is transmitting correctly by setting interrupt flag in status register but when i transmit register address it is not transmitting it is hanging there only when is check interrupt flag in while loop. I am not getting whats the issue. Please help me out.

Iam using I2C baud of 100k. I am attaching my code please check it once

Thanking You

Re: I2C protocol interfacing Accelerometer MMA7660fc

nxf56274 — Tue, 24 Dec 2019 05:50:23 GMT

Hi,

Sorry for the late. We have the latest library in our website "https://mcuxpresso.nxp.com/en/select ", you can try it. Please tell me which register you can't write.

Have a great day,
TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: I2C protocol interfacing Accelerometer MMA7660fc

mdrasool_yadwad — Tue, 24 Dec 2019 09:47:50 GMT

Hello Da Li,

Sir actually the problem is when i debug by using break points it is updating but once i run without break point is not working. When i check the status register the interrupt flag is not raising after sending the register address of the slave.

And one more thing when i configure accelerometer by writing to the register 07 to change to the active mode and starts reading the accelerometer it is not giving the output. whether i need any configurations to update.

Thanking You,

Mohammedrasool

Re: I2C protocol interfacing Accelerometer MMA7660fc

nxf56274 — Wed, 25 Dec 2019 01:11:21 GMT

Hi,

You would be better to try the latest library in our website "https://mcuxpresso.nxp.com/en/select ". And using debugger to debug the communication protocol will influence the timing sequence of i2c. Use logic analyzer or oscilloscope to watch wave.

Have a great day,

TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

Re: I2C protocol interfacing Accelerometer MMA7660fc

mdrasool_yadwad — Wed, 25 Dec 2019 03:29:32 GMT

Hello,

I have taken screenshot let you see this. After giving values for few iterations the master switches to the slave automatically.

Re: I2C protocol interfacing Accelerometer MMA7660fc

nxf56274 — Wed, 25 Dec 2019 05:56:21 GMT

Hi,

We no longer support the codewarrior. If the code have some problems, please use the latest library and our free tool MCUXpresso.

Have a great day,

TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!