topic Re: Hardware fault when reading a register in Kinetis Microcontrollers

Hardware fault when reading a register

gmgjeg — Thu, 20 Dec 2018 15:49:58 GMT

Hardware fault when reading a register

mjbcswitzerland — Thu, 20 Dec 2018 16:53:15 GMT

Usually because the module being accessed doesn't have its clock enabled to it.
See SIM_SCGCx control.

Regards

Mark

gmgjeg — Thu, 20 Dec 2018 21:13:48 GMT

Thank you, I will make sure it is enabled.

On Thursday, December 20, 2018, 11:54:36 AM EST, mjbcswitzerland <admin@community.nxp.com> wrote:

NXP Community

Re: Hardware fault when reading a register

reply from Mark Butcher in Kinetis Microcontrollers - View the full discussion

Usually because the module being accessed doesn't have its clock enabled to it.

See SIM_SCGCx control.

Regards

Mark

Reply to this message by replying to this email, or go to the message on NXP Community

Start a new discussion in Kinetis Microcontrollers by email or at NXP Community

Following Re: Hardware fault when reading a register in these streams: Inbox

This email was sent by NXP Community because you are a registered user.

You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences

gmgjeg — Fri, 21 Dec 2018 17:37:53 GMT

Thank you for the help.

On Friday, December 21, 2018, 5:56:05 AM EST, kerryzhou <admin@community.nxp.com> wrote:

NXP Community

Hardware fault when reading a register

Kerry Zhou marked Mark Butcher's reply on Hardware fault when reading a register as helpful. View the full reply

Marked as helpful:

Usually because the module being accessed doesn't have its clock enabled to it.

See SIM_SCGCx control.

Regards

Mark

Following Hardware fault when reading a register in these streams: Inbox

This email was sent by NXP Community because you are a registered user.

You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences