topic Re: RTC does not advance time counter in Kinetis Microcontrollers

RTC does not advance time counter

mscovel — Sun, 18 Mar 2018 00:38:31 GMT

The RTC Time Seconds Register (TSR) and Timer Prescaler Register (TPR) do not increment while the K65 is running/single stepping (nor powered off with a battery connected).

The tower does not have this problem. Both TSR and TPR run (constantly increment) and when powered off/on the TSR is updated to reflect the elapsed time.

Furthermore, the KSDK example rtc_example_twrk65f180m sets an RTC alarm and waits for it to happen. This works on the tower and not on our board.

I'm thinking there is some K65 errata that Freescale/NXP don't know about yet.

Could this be related to MCG clock speed?

Has anybody seen this problem or does anyone have any idea how to fix it?

Re: RTC does not advance time counter

mjbcswitzerland — Sun, 18 Mar 2018 13:29:31 GMT

Hi Mark

Check your 32kHz crystal on your own HW - without this oscillating the time will never increment (as in your case).
If this is not the cause, check that the RTC oscillator intialisation has not been missed somehow; ie. setting RTC_CR_OSCE bit in RTC_CR.

Regards

Mark

Kinetis: http://www.utasker.com/kinetis.html
Kinetis K66:
- http://www.utasker.com/kinetis/TWR-K65F180M.html
- http://www.utasker.com/kinetis/FRDM-K66F.html
- http://www.utasker.com/kinetis/TEENSY_3.6.html

Free Open Source solution: https://github.com/uTasker/uTasker-Kinetis
Working project in 15 minutes video: https://youtu.be/K8ScSgpgQ6M

For better, faster, cheaper product developments consider the uTasker developer's version, professional Kinetis support, one-on-one training and complete fast-track project solutions to set you apart from the herd : http://www.utasker.com/support.html

Re: RTC does not advance time counter

mscovel — Sun, 18 Mar 2018 13:34:45 GMT

That’s good info Mark. Thank you!

Thanks

Mark Scovel

Re: RTC does not advance time counter

mscovel — Mon, 19 Mar 2018 23:54:07 GMT

That's what was wrong. The RTC oscillator was not running. Thanks Mark!

Re: RTC does not advance time counter

deniscollis — Thu, 14 Jun 2018 00:43:39 GMT

I had the same problem with a custom K81 board. The RTC did not run with any new MCUXpresso project. But it did run with some example code. On investigation I found that the watchdog setup in the demo checked and set the RTC CR OSCE bit, because it needed the RTC Time Alarm. The side-effect was that the RTC ran beautifully... until I disabled the watchdog. To preserve sanity I set the OSCE bit right after the RTC_Init

 rtc_config_t rtcConfig;
 RTC_GetDefaultConfig(&rtcConfig);
 RTC_Init(RTC, &rtcConfig);
 RTC->CR |= RTC_CR_OSCE_MASK; // Enable Oscillator
 RTC_StartTimer(RTC);