MKE04Z IC DEBUG KWIKSTIK SWD

alexloban — Fri, 08 Jun 2018 04:58:08 GMT

Dear Kinetis Community,

im very new in embedded system. And have now a first problem.

Im buy me Kinetis MKE04Z8VTG4 chips in TSSOP 16 package and place one on a pcb.

Buy me SWD Cable, Connector adapter to DIP.

And Kwikstik SWD connecter (J8).

All parts are placed.

In Kwikstik manual i have read i can debug via J8 connector all Kinetis IC's.

I connect Kwikstik and MKE04Z, start J-Link flash and try to erase chip. and get error,

can not connect.

HOW I CAN COUNT PINS of SWD connector wich direction ? FROM LEFT TO RIGHT ? UP AND DOWN ??

DATASHEET KWIKSTIK DEBUG SWD

DATASHEET MKE04Z BUT I DONT SEE A POINT OF PIN COUNTING ON THE CHIP I SEE A ROUND MARK LIKE IMAGE DOWN.

PIN MAPPING

MY CONNECTION.

It was my first experience. And im sure i do something wrong or its no possible do flash or debug with kwikstik.

I have direct cables to the pins without capacitor, resistors.

Can you help me ?

If it no possible to debug, pleas tell me a little bit what i need to flash chip. i will start a project with out dev board :smileyhappy: only PCB.

THANK YOU VERY MUCH !

alex#

Re: MKE04Z IC DEBUG KWIKSTIK SWD

adamsojecki — Sun, 10 Jun 2018 20:03:21 GMT

Here's the correct numbering of the pins SWD connector on KwikStik.

Good luck,

Adam.