topic Re: Looking for K60 pin mux tool. in Kinetis Microcontrollers

Looking for K60 pin mux tool.

yulistarodubtse — Thu, 29 Dec 2016 15:24:28 GMT

Hi, I am looking for MK60FN1M0VLQ12 pin mux tool. It did exist in Freescale times; I am sure because I have used it. the new MCUXpresso certainly has a fancy name and cool interface, but the number of possible processors is very, very limited. Like a Nexpresso coffee machine :smileyhappy:

Re: Looking for K60 pin mux tool.

Hui_Ma — Tue, 03 Jan 2017 06:55:43 GMT

So far, [Pins Tool] does not support K60_120MHz product. Customer could using CodeWarrior for MCU V10.7 Processor Expert tool to do pin muxing as below picture shows:

The CodeWarrior for MCU V10.7 software could be downloaded from here.

Wish it helps.

Have a great day,
Ma Hui
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Looking for K60 pin mux tool.

yulistarodubtse — Wed, 04 Jan 2017 16:48:05 GMT

Hi Ma Hui,

my problem is that the processor in question is not on the list of PE available processors. So, I am not sure how did you get to that screen. Did you select some development board? please advise.

Best regards,

Yuli

Re: Looking for K60 pin mux tool.

Jonathan_Iglesias — Wed, 04 Jan 2017 18:28:59 GMT

DeaYuli Starodubtsev,

Please check this tool MCUXpresso Config Tools|NXP.

there is a web version or a download one.

Hope this works.

Have a great day

Jonathan

Re: Looking for K60 pin mux tool.

yulistarodubtse — Wed, 04 Jan 2017 19:43:38 GMT

Hi Jonathan,

thank you. the problem is - the processor of interest is not on the list. the closest processor on the list doesn't have two I2S channels, which I need.

thank you,

Yuli

Re: Looking for K60 pin mux tool.

Jonathan_Iglesias — Wed, 04 Jan 2017 20:14:15 GMT

Sorry I did not saw the entire part number, I think the Hui_Ma solution would be the best.

Jonathan

Re: Looking for K60 pin mux tool.

Hui_Ma — Thu, 05 Jan 2017 00:37:41 GMT

It need to use CodeWarrior for MCU V10.7 software.

During new project creation phase, I select to use this device:

Wish it helps.

Re: Looking for K60 pin mux tool.

yulistarodubtse — Tue, 10 Jan 2017 20:02:18 GMT

Hi Ma Hui,

Your advice does work, thank you. However it seems to me that I have to assign the pins manually. Is it so, or is there some automation on pin muxing available?

Thank you again,

Yuli

Re: Looking for K60 pin mux tool.

Hui_Ma — Wed, 11 Jan 2017 02:55:17 GMT

Using this way, it needs to config used module related processor expert component manually. Then during the code generation phase, the related pin muxing code will be generated.

There without another automatic pin muxing method so far (K60_120MHz product) .

Sorry for that may causing any inconvenience to you.

Thank you for the attention.

Re: Looking for K60 pin mux tool.

yulistarodubtse — Wed, 25 Jan 2017 19:20:02 GMT

Thank you. Had to switch to another processor, that is better supported by existing tools - MK64FN1M0VLL12. Looks like the previous one is being phased out.