Kinetis MicrocontrollersのトピックRe: K70 Nandflash programming with P&E Cyclone Fx?

K70 Nandflash programming with P&E Cyclone Fx?

arnogir — Mon, 24 Apr 2017 12:49:01 GMT

Hello,

I post this question on P&E micro forum but without success since many month!

So I try here! :

I asked in the P&E micro forum if Nandflash algorithm is possible with Cyclone FX.

Somebody answer me NandFlash is not supported but I don't know if it is because no algorithm exist yet or if Cyclone Hardware is not designed for this?

Because Kinetis has a NandFlash Controler (NFC). It will be damaging that the Cyclone does not know how to do it! My post is here:

http://www.pemicro.com/forums/forum.cfm?forum_topic_id=5230&forum_id=7#c13556

Then NandFlash DataSheet is here: http://datasheet.octopart.com/MT29F2G08ABAEAWP%3AE-Micron-datasheet-11549997.pdf

And I attached the Scheme of the used board on my side (SQM4-K70) Manufacturer website:
http://www.sqm4.com/sqm4-k70-kinetis-module-eeprom

Then It is possible to have an algorithm which will be able with the Cyclone to Dump the External NandFlash Memory and write it?

Thank you

Re: K70 Nandflash programming with P&E Cyclone Fx?

arnogir — Tue, 02 May 2017 13:24:46 GMT

Hello

Nobody can help me about this?

Re: K70 Nandflash programming with P&E Cyclone Fx?

arnogir — Tue, 23 May 2017 06:36:11 GMT

Hello

It's been 9 months since I tried to get an answer to this question without success.
We have invested in the Cyclone in order to optimize our production.

Today we have several orders and a large volume to produce. I would like to have the answer to my question in order to prepare this production as well as possible.

Is somebody can help me?

Re: K70 Nandflash programming with P&E Cyclone Fx?

johnny_pe — Fri, 23 Jun 2017 20:44:38 GMT

Arnaud,

We currently do not support NAND Flash programming. All of our flash
programming capabilities only supports NOR flash programming. So we cannot support your Flash setup.

Regards,

Johnny

PEmicro