Kinetis MicrocontrollersのトピックRe: toggling program flash protection mk22fn1m0vlh12

toggling program flash protection mk22fn1m0vlh12

daafies — Sat, 21 Jan 2017 06:53:39 GMT

hi i'm trying to turn on and off flash protection. i can see how to do it in PE or by using

/* Flash configuration field */
__attribute__ ((section (".cfmconfig"))) const uint8_t _cfm[0x10] = {
/* NV_BACKKEY3: KEY=0xFF */
0xFFU,
/* NV_BACKKEY2: KEY=0xFF */

etc

but how do i change the following field in my application:

/* NV_FPROT3: PROT=0xFF */
0xFFU,
/* NV_FPROT2: PROT=0xFF */
0xFFU,
/* NV_FPROT1: PROT=0xFF */
0xFFU,
/* NV_FPROT0: PROT=0x7F */

i tried

NV_FPROT3 = 0xFF;
NV_FPROT2 = 0xFF;
NV_FPROT1 = 0xFF;
NV_FPROT0 = 0x7F;

but that causes hard fault. i can read from those however.

thanks for help

dave

Re: toggling program flash protection mk22fn1m0vlh12

mjbcswitzerland — Sat, 21 Jan 2017 17:16:10 GMT

Hi Dave

1. NV_FPROTn is an address in Flash and so you can't write to it from your code (it gives you your hard fault).
2. You can "enable" protection also by writing the FPROTn register (in the FTFE module itself - address 0x40020010..13)
3. Once protection has been enabled YOU CAN NOT DISABLE it (without either reprogramming the values in the Flash Configuration area, or by a reset if set manually).

For full details see the video:
https://youtu.be/c9GRYXFs9LU

Regards

Mark

Re: toggling program flash protection mk22fn1m0vlh12

daafies — Tue, 24 Jan 2017 19:33:58 GMT

thanks Mark!