topic Re: FRDM KL82Z Bootloader, which File? in Kinetis Microcontrollers

FRDM KL82Z Bootloader, which File?

us1 — Tue, 11 Oct 2016 12:18:33 GMT

Hello,

I want to use the FRDM-KL82Z Board with the Kinetis Design Studio.

What do I need to upload on the Bootloader?

I couldn't find any file for it in the KDS folder, only for other boards.

How could I get started with it? I wanted to use the "Hello World" Example.

Thank you a lot

Re: FRDM KL82Z Bootloader, which File?

Jonathan_Iglesias — Wed, 12 Oct 2016 19:41:01 GMT

Dear Ulrich Ulrich Steinlehner,

I attached the file. Connect the device in bootloader mode. then in my PC drag the file into the BOOTLOADER, then unplug the board and plug it again. you should be able to debug from KDS, in the configuration select J-link or segger.

The steps to download the specific file for your board are these in case you wanted to know.

Go to SEGGER - The Embedded Experts
then search for OPEN SDA and click in the first link that should send you here SEGGER - The Embedded Experts - OpenSDA / OpenSDA V2
There is a table of the boards and the version needed for each board.
in the bottom of the page in the " Updating a Board That is Already Running J-Link OpenSDA Firmware " section you will find a link click it.
the page should send you here SEGGER - The Embedded Experts - Downloads - J-Link / J-Trace
then look for this
and download the version for your board.

Hope this works.

Have a great day.

Best Regards

-Jonathan

Re: FRDM KL82Z Bootloader, which File?

us1 — Thu, 13 Oct 2016 07:04:37 GMT

Ok,

thank you. Was looking for a pemicro opensda file.

Thank you a lot

Re: FRDM KL82Z Bootloader, which File?

Jonathan_Iglesias — Thu, 13 Oct 2016 19:15:12 GMT

P&E Microcomputer Systems: Over 30 years as an Industry leader in Embedded Systems Development Tools, debug probes, and …

Check this !.

it is a pleasure to help.

Best Regards

-Jonathan