topic Re: Kinetis KL03 - Program retention after power cycle in Kinetis Microcontrollers

Kinetis KL03 - Program retention after power cycle

armaram — Mon, 10 Oct 2016 17:21:38 GMT

Hi,

My #kl03 doesn't retain program after power cycle. We must reprogram the MCU in order to continue working. We are using the PE Micro Multilink FX cable to program the MCU.

Can anyone pls help?

Thanks,

Arvind

Re: Kinetis KL03 - Program retention after power cycle

miduo — Tue, 11 Oct 2016 07:29:44 GMT

Hi,

Please let me know what board you used and what software used? I mean the flash programming method. What steps you had done and if any error reported?

Re: Kinetis KL03 - Program retention after power cycle

armaram — Tue, 11 Oct 2016 11:42:29 GMT

It's a custom hardware board. We use

-KSDK1.3.1.

-Programming cable - PEMicro multilink fx

-SWD port

Pls let me know if you need any further information.

No errors reported. Only that we have to reprogram the MCU everytime we do a power cycle. We want the program to be retained even when power is turned OFF/ON.

Re: Kinetis KL03 - Program retention after power cycle

armaram — Mon, 07 Nov 2016 12:55:07 GMT

@Fang Li any help would be great!

Re: Kinetis KL03 - Program retention after power cycle

gnichimohamed — Mon, 07 Nov 2016 14:49:20 GMT

Check if nmi_b pin is low or pulled down low then you need to disable nmi.

Re: Kinetis KL03 - Program retention after power cycle

armaram — Sun, 26 Feb 2017 12:00:12 GMT

Yes, in fact that was the problem. One of the NXP guys helped us out but I missed to post the update. Thank you though!