Kinetis MicrocontrollersのトピックStart with TWR-K60N512

Start with TWR-K60N512

jirikral — Sun, 30 Oct 2016 18:54:26 GMT

Hello,

I have kit TWR-K60N512 Rev. D and I want to use IAR Embedded Workbench IDE.
I installed drivers (PEMicro USB Serial Port, WinDriver, Open Source BDM-Debug Port).

When I download a program I confirm

"Old OSJTAG/OSBDM firmware has been detected. The embedded firmware needs to be in bootloader mode to update. Please unplug the USB cable, insert a jumper on the 2-pin bootloader header (connecting JM60 IRQ to ground), and reconnect the USB cable."

While using Firmware Update and Architecture Selection Utility (PE micro) and again ends Confirm "...... the 2-pin bootloader header (connecting JM60 IRQ to ground) ......."

According to the scheme must be shorted header J10, but for such a kit is not. I believe that this is the J12, but even after shorting to get away. Please ask me.

Thanks in advance,

Jiri

Re: Start with TWR-K60N512

kerryzhou — Fri, 04 Nov 2016 03:25:07 GMT

Hi Jiri Kral,

In TWR-K60DN512 REV D, you should also use J10, not J12, J10 is the bootloader enable interface.

Please refer to this schematic:

http://cache.nxp.com/files/32bit/hardware_tools/schematics/TWR-K60N512-SCH_D.pdf?fpsp=1&WT_TYPE=Schematics&WT_VENDOR=FRE…

Please follow the notification, do the according operation in J10.

Wish it helps you!

If you still have question, please contact me!

Have a great day,
Kerry

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Start with TWR-K60N512

jirikral — Tue, 08 Nov 2016 08:15:24 GMT

I have found and used J10. Currently I made progress in such a way that I have in Device Manager files:

- Jungo (WinDriver)

- LibUSB-Win32 Devices (OSBDM/OSJTAG - Debug Port (http://www.pemicro.com/osbdm)

- Ports (COM a LPT) (OSBDM/OSJTAG - CDC Serial Port (http://www.pemicro.com/osbdm, http://www.pemicro.com/opensda)(COM23)
Whole action terminated with notice that the device is connected and is working correctly.

Furthermore, I am not successful. I try to download sample project GPIO from examples in IAR Embedded Workbench IDE, version 7.30. In the project I have set Options - Debuger - PE micro – OSJtag. Then I proceed with “Make”, nevertheless, when I try download I get the notice “The flash loader program reporte an error“. Then I click Enter and further notice “A fatal error has occurred. The debugger will terminate.“

Please could you help me?

Re: Start with TWR-K60N512

kerryzhou — Tue, 08 Nov 2016 09:42:35 GMT

Hi Jiri Kral,

Did you install the PE driver?

Follow P&E Microcomputer Systems: Over 30 years as an Industry leader in Embedded Systems Development Tools, debug probes, and …

Beside, please use my attached TWR-K60N512 sample code, and try again.

If you still have problem, please also attached your problem picture.

Have a great day,
Kerry