Kinetis Microcontrollers中的主题 Re: How to setup I2c communication? https://community.nxp.com/t5/Kinetis-Microcontrollers/How-to-setup-I2c-communication/m-p/612003#M36226 <HTML><HEAD></HEAD><BODY><P>Hi, </P><P></P><P>Please let me know first that which board you are using? NXP evaluation board or customer board? It should been figure out if the hardware issue or software regarded.</P></BODY></HTML> Sun, 09 Oct 2016 08:34:42 GMT miduo 2016-10-09T08:34:42Z How to setup I2c communication? https://community.nxp.com/t5/Kinetis-Microcontrollers/How-to-setup-I2c-communication/m-p/612002#M36225 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>I am using KSDK 2.0 for using i2c in k66 MCU.</P><P>As per the I2C protocol on sending the start signal only SDA line should be pulled low and SCL should be high.But in my board both SDA and SCL are low.</P><P>Because of this I am not getting ACK after sending the my slave address</P></BODY></HTML> Thu, 06 Oct 2016 14:32:05 GMT https://community.nxp.com/t5/Kinetis-Microcontrollers/How-to-setup-I2c-communication/m-p/612002#M36225 karthikpoojary 2016-10-06T14:32:05Z Re: How to setup I2c communication? https://community.nxp.com/t5/Kinetis-Microcontrollers/How-to-setup-I2c-communication/m-p/612003#M36226 <HTML><HEAD></HEAD><BODY><P>Hi, </P><P></P><P>Please let me know first that which board you are using? NXP evaluation board or customer board? It should been figure out if the hardware issue or software regarded.</P></BODY></HTML> Sun, 09 Oct 2016 08:34:42 GMT https://community.nxp.com/t5/Kinetis-Microcontrollers/How-to-setup-I2c-communication/m-p/612003#M36226 miduo 2016-10-09T08:34:42Z