topic Re: How best to verify flash programming on K24 in Kinetis Microcontrollers

How best to verify flash programming on K24

marks — Fri, 24 Feb 2017 16:19:51 GMT

Hello, A customer of ours would like to verify the firmware programmed into the flash on a K24 through the JTAG or SWD port. The boards have been assembled and programmed in another location and there are also various revisions of the firmware. I understand some of the P&E Micro Cyclones can verify against a .S19 file. Are there other options or methods to do this?

Thanks!

Mark

Re: How best to verify flash programming on K24

BlackNight — Fri, 24 Feb 2017 16:29:29 GMT

You can use any debug probe connected to the target and then use Eclipse memory view to export the memory as S19, see Dump my Device Memory | MCU on Eclipse .

Another option with a SEGGER you can use remote access (see Remote Board Debugging: J-Link Remote Server with Eclipse | MCU on Eclipse ), for this you need a probe attached and some kind of network access, if you have to do this from remote.

I hope this helps,

Erich