Kinetis Microcontrollers中的主题 Re: Changes required for converting from RMII to MII

Changes required for converting from RMII to MII

Mohsin455 — Thu, 09 Feb 2012 01:03:36 GMT

Hi All,

I am using TWRK60N512 and MQX 3.8. I am using KSZ8895MQ with MII Interface on my custom board. I know there are issues, such that TWRK60N512 cannot be used in MII mode (as some of the pins are use for JTAG) but I will be trying this on custom board.

I want to know what are the changes required in the MQX code for TWRK60N512 in order to convert from RMII to MII Interface.

Thanks,

Mohsin

Re: Changes required for converting from RMII to MII

egoodii — Sat, 31 Mar 2012 03:19:15 GMT

The one obvious change in ...\MQX_RTOS\mqx\source\bsp\twrk60n512\init_enet.c structure:

const ENET_PARAM_STRUCT ENET_default_params[BSP_ENET_DEVICE_COUNT] = {

{

&ENET_0,

Auto_Negotiate,

ENET_OPTION_RMII | ENET_OPTION_PTP_MASTER_CLK,

BSPCFG_TX_RING_LEN, // # tx ring entries

BSPCFG_TX_RING_LEN, // # large tx packets

ENET_FRAMESIZE, // tx packet size

BSPCFG_RX_RING_LEN, // # rx ring entries

BSPCFG_RX_RING_LEN, // # normal rx packets - must be >= rx ring entries

ENET_FRAMESIZE, // ENET_FRAMESIZE, // rx packet size

BSPCFG_RX_RING_LEN, // # rx PCBs - should be >= large rx packets.

}

};

is to remove ENET_OPTION_RMII.

Yes, at a hardware level you will lose your JTAG 'trace' function (so of course mux them to ENET, such as in init_gpio.c).

Changes to the phy interface routines in ...\MQX_RTOS\mqx\source\io\enet\phy\phy_xxx are another matter. Maybe you will luck out and your PHY will work with the 'common subset'.

--ERGII

Re: Changes required for converting from RMII to MII

Mohsin455 — Mon, 02 Apr 2012 01:59:53 GMT

Hi ERGII,

Thanks for your reply. What do you mean by " at a hardware level you will lose your JTAG 'trace' function (so of course mux them to ENET, such as in init_gpio.c)"

Thanks,

Mohsin