topic Re: Programming samples in Kinetis Microcontrollers

Programming samples

jackmonaghan — Thu, 20 Aug 2015 10:46:52 GMT

how do i upload my program to the samples

Re: Programming samples

Carlos_Mendoza — Thu, 20 Aug 2015 14:04:33 GMT

Hi Jack,

Could you tell us which IDE and MCU are you using?

Best Regards!

Carlos Mendoza

Technical Support Engineer

Re: Programming samples

jackmonaghan — Thu, 20 Aug 2015 22:23:21 GMT

IM using KDS and I'm using the KL43Z MCU

Re: Programming samples

kerryzhou — Fri, 21 Aug 2015 06:55:07 GMT

Hi Jack Monaghan,

I don't know which programmer you are using, but the configuration in the KDS is nearly the same, you should choose the according debug interface, after you connect the programmer to your board with SWD interface, then click debug, the program will download to your chip.

Here, I take PE opensda as an example:

In KDS, choose RUN-> debug configurations, then choose GDB PEMicro Interface debugging-> KL43_TEST_Debug

Choose the interface as your programmer(here is OPENSDA), then click button debug, wait the flash download finished, then your chip will be programmed.

Wish it helps you!

Any question, please contact me.

Have a great day,
Jingjing

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Programming samples

_markus_ — Fri, 21 Aug 2015 09:05:20 GMT

Hello Jungjing and all other :-)

I think I have the same problem. I have a Sensortoolbox evaluation board and I can't get in connection.

The problem is that the port will not detected. I have tryed many time to install the driver from P&E. But no success :...(

And It looks like I have a diffrend version of code waarior than you. I use 10.6.

Please can give me somebody some assistance?

THANK YOU ALL!!!

Re: Programming samples

kerryzhou — Mon, 24 Aug 2015 03:17:52 GMT

Hi markus,

Your problem is not caused by the CW10.6, your problem may caused by your Multilink, you should install the PE Multilink driver and make sure the hardware of your USB multilink is not broken.

It seems that your USB multilink still not connect correctly to your PC, about this question, I think you should ask it to the P&E micro's engineer, they may help you install it correctly. P&E 's web is : www.pemicro.com

Wish it helps you!

Regards,

Jingjing