Kinetis Microcontrollers中的主题 Communications between Matlab and KL25Z. https://community.nxp.com/t5/Kinetis-Microcontrollers/Communications-between-Matlab-and-KL25Z/m-p/320039#M14314 <HTML><HEAD></HEAD><BODY><P>Hey community!</P><P></P><P>I'm on a summer internship where I am attempting to create a project but I'm struggling to figure out where to start. I would like to have my KL25Z transmit data to my computer (about it's state, or the state of peripherals like the TSI and maybe GPIO stuff likes simple buttons). </P><P></P><P>Would anyone suggest a direction to start looking into. This should be communicating through the USB cord. The reference manual for USB-OTG is mind blowing and I'm not even sure how I'd program the computer to read the USB port without programming a whole driver (which I heard is super tough). </P><P></P><P>Any suggestions?</P><P></P><P>-Nico</P></BODY></HTML> Mon, 14 Jul 2014 14:59:29 GMT nicopinkowski 2014-07-14T14:59:29Z Communications between Matlab and KL25Z. https://community.nxp.com/t5/Kinetis-Microcontrollers/Communications-between-Matlab-and-KL25Z/m-p/320039#M14314 <HTML><HEAD></HEAD><BODY><P>Hey community!</P><P></P><P>I'm on a summer internship where I am attempting to create a project but I'm struggling to figure out where to start. I would like to have my KL25Z transmit data to my computer (about it's state, or the state of peripherals like the TSI and maybe GPIO stuff likes simple buttons). </P><P></P><P>Would anyone suggest a direction to start looking into. This should be communicating through the USB cord. The reference manual for USB-OTG is mind blowing and I'm not even sure how I'd program the computer to read the USB port without programming a whole driver (which I heard is super tough). </P><P></P><P>Any suggestions?</P><P></P><P>-Nico</P></BODY></HTML> Mon, 14 Jul 2014 14:59:29 GMT https://community.nxp.com/t5/Kinetis-Microcontrollers/Communications-between-Matlab-and-KL25Z/m-p/320039#M14314 nicopinkowski 2014-07-14T14:59:29Z