PE_DEBUGHALT();

HIMU — Sat, 19 Apr 2014 20:28:21 GMT

Greets.

I am trying to make work a Kinetis K20DX128, but when PE start there is a problem:

And there it stays, like a loop.

If any of you have any suggestion, i will appreciate it.

Thanks.

HM.

Re: PE_DEBUGHALT();

Jorge_Gonzalez — Sun, 20 Apr 2014 00:08:30 GMT

Hello Hector:

This could be a problem with the silicon mask revision. Is this a project created by you or an example project by Freescale?

When creating a project for the K20X128 (100 MHz as I see in your picture), you have three options:

- PK20X128 and MK20DX128Z correspond to silicon Rev 1.x.

- MK20DX128 is for silicon Rev 2.x.

You need to check the label on the top of your MCU, refer to AN4445 for full details and select the proper device accordingly.

I hope this is helpful!

Regards!,
Jorge Gonzalez

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: PE_DEBUGHALT();

HIMU — Sun, 20 Apr 2014 05:05:35 GMT

Dear Jorge.

Thanks a lot for your help, it would have blown my mind.

Sincerely.

topic Re: PE_DEBUGHALT(); in Kinetis Microcontrollers

PE_DEBUGHALT();

Re: PE_DEBUGHALT();

Re: PE_DEBUGHALT();