Debugger and programmers for KE02

johny — Fri, 11 Apr 2014 17:32:53 GMT

Hi,

I recently started using MKE02Z32VLC4 in my designs and I found that programming and debugging is not a straight forward with Jlink Pro and does not work with IC5000. What are the proven hardware debuggers that works with this Kinetis device ?

Regards,

Re: Debugger and programmers for KE02

santiago_lopez — Fri, 11 Apr 2014 18:50:44 GMT

Hi Johny,

You should be able to connect with the KE02 using your Jlink Pro. All you need to do is connect it to the SWD pins on your microcontroller.

The image above shows the SWD pins position in a Jlink Pro 20-pin connector. You need to do the following connections:

JLink Pin MCU Pin

SWDIO --> SWD_DIO

SWCLK --> SWD_CLK

RESET --> RESET

VTref --> VDD

GND --> VSS

If needed, configure your Jlink to communicate through SWD (it typically detects it automatically)

Hope it helps

Saludos

topic Re: Debugger and programmers for KE02 in Kinetis Microcontrollers

Debugger and programmers for KE02

Re: Debugger and programmers for KE02