topic How to enable the internal 1.5K-ohm pull-up resister in the USB PHY? in i.MX RT Crossover MCUs

How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

david9991 — Mon, 03 Sep 2018 08:36:40 GMT

In IMXRT1050 reference manual it said:

56.2.5.4 Switchable 1.5KΩ USB_DP Pullup Resistor
This product contains a switchable 1.5 KΩ pullup resistor on the USB_n_DP signal.
This resistor is switched on to indicate to the host/hub controller that a full-speed-capable device is on the USB cable, powered on, and ready. This resistor is switched off at power-on reset so the host does not recognize a USB device until the processor software enables the announcement of a full-speed device.

but hasn’t mentioned how to enable this internal pull-up resistor, and I cannot find any external pull-up resister on the board, so my PC cannot detect if device plugged in. What should I do now?

Re: How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

igorpadykov — Tue, 04 Sep 2018 00:02:41 GMT

Hi David

usb module controls this bit automatically internally during usb connection

procedure, seems there is no way to manually in software control it.

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

david9991 — Tue, 04 Sep 2018 00:26:09 GMT

But how to explain: This resistor is switched off at power-on reset so the host does not recognize a USB device until the processor software enables the announcement of a full-speed device"

Re: How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

david9991 — Tue, 04 Sep 2018 01:52:33 GMT

And my device does undetectable in this moment. I think USB port is just a analog detectable circuit, when the pull-up on DP or DN was detected, HOST should send the description request automatically without any other condition, even USB control not be started right? I tried use Wireshark to monitor the USB request, but nothing was captured.

Re: How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

igorpadykov — Tue, 04 Sep 2018 05:44:22 GMT

what is about other devices, USB module perform enumeration process using on own state machine,

you can try examples with i.MXRT1050 EVK and its MCUXpresso software

Welcome | MCUXpresso SDK Builder

Best regards
igor

Re: How to enable the internal 1.5K-ohm pull-up resister in the USB PHY?

david9991 — Tue, 04 Sep 2018 08:03:22 GMT

With some investigation I found the point: the RAM region have not been mark to 'shareable' in the MPU.

Thank you all the same. :smileywink: