topic Re: How to Read/Write eFuses in J-Link commander? in i.MX RT Crossover MCUs

How to Read/Write eFuses in J-Link commander?

burns_wayne — Wed, 21 Nov 2018 02:37:59 GMT

Hi,

I’m using a J-Link to program a NXP MCIMXRT1052 chip, and need to program/blow some of its eFuse registers.

However, I've troubles even reading the eFuse registers, let along writing them, in J-Link Commander.

According to Table 5-9 in the MCIMXRT1052 datasheet, register at 0x420 should contain Unique ID of the chip. However, when I do a "mem 420,10" command in J-Link Commander, to read the content at the 0x420 address, it just returns a bunch of neatly count-up numbers, just like all other eFuse registers, which can't be right. (Please have a look at the attached screanshot below)

Have I just typed in a wrong address? or where else could have gone wrong?

Cheers

Larry

Re: How to Read/Write eFuses in J-Link commander?

igorpadykov — Thu, 22 Nov 2018 00:58:49 GMT

Hi Larry

one can try example from below link and implement it with jlink:

How to burn BT_FUSE_SEL on RT1050

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: How to Read/Write eFuses in J-Link commander?

jay_heng — Sun, 23 Dec 2018 05:03:30 GMT

You can try this tool to read fuse

GitHub - JayHeng/nxp-sec-boot-ui: A one-stop GUI tool to work with NXP MCU (Kinetis, i.MXRT, LPC) ROM bootloader, It can…