JTAG Debugger/Programmer for RT1170 processors

LuisC — Thu, 04 May 2023 17:02:17 GMT

Hello,

I'm looking for information on a recommended JTAG Debugger/Programmer that could be used with the RT1172 processor? Also I was hoping for some clarification on the pins of the RT1172 that will be needed to interact wit the JTAGC controller. In the reference manual there is JTAG compliance signal (JCOMP) that is not mentioned in the data sheet.

Re: JTAG Debugger/Programmer for RT1170 processors

jingpan — Fri, 05 May 2023 02:22:12 GMT

Hi @LuisC ,

You can use Jlink(V9 and above) and ulink. These NXP devices are also recommended.

https://www.nxp.com/design/software/development-software/mcuxpresso-software-and-tools-/mcu-link-debug-probe:MCU-LINK

https://www.nxp.com/design/software/development-software/mcuxpresso-software-and-tools-/mcu-link-pro-debug-probe:MCU-LINK-PRO

You can refer to RT1170 EVK schematic for how to connect jtag port.

https://www.nxp.com/webapp/Download?colCode=MIMXRT1170-EVK-DESIGNFILES

Regards,

Jing

topic Re: JTAG Debugger/Programmer for RT1170 processors in i.MX RT Crossover MCUs

JTAG Debugger/Programmer for RT1170 processors

Re: JTAG Debugger/Programmer for RT1170 processors