i.mx28 NAND flash programming using JTAG

SteveO1z — Tue, 28 Feb 2017 20:43:05 GMT

Hello. I have been asked if it is possible to program the NAND flash using JTAG in a manufacturing environment. We are using an i.mx28 with a NAND flash connected through the GPMI. Has anyone had experience with this process? Is this practical in a MFG environment? We have maintained the standard 8-pin connector from the SDK. Any suggestions on tools or known issues would be greatly appreciated. Thanks in advance!

Steve O

Re: i.mx28 NAND flash programming using JTAG

igorpadykov — Tue, 28 Feb 2017 23:47:49 GMT

Hi Steve

typical option is to use mfg tools for nand programming

Programmers (Flash, etc.) (6)

i.MX287 Processors|Dual Ethernet|NXP

unfortunately I am not aware of jtag programming options.

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

i.MX ProcessorsのトピックRe: i.mx28 NAND flash programming using JTAG

i.mx28 NAND flash programming using JTAG

Re: i.mx28 NAND flash programming using JTAG