topic Re: i.MX28 Linear Regulator Status in i.MX Processors

i.MX28 Linear Regulator Status

lategoodbye — Fri, 19 Sep 2014 18:50:44 GMT

Hi,

i'm currently working on a Mainline Linux driver for the linear regulators (vddd, vdda, vddio, vddmem) of the i.MX28.

Which hardware register values are prefered to check the current regulator state (enabled / disabled)?

Best regards

Stefan Wahren

Re: i.MX28 Linear Regulator Status

JorgeRama_rezRi — Fri, 19 Sep 2014 19:48:26 GMT

Hi Stefan,

For VDDD, VDDA and VDDMEM you can check their respective ENABLE_LINREG bits in their control registers:

HW_PWR_VDDDCTRL 0x8004_4040

HW_PWR_VDDACTRL 0x8004_4050

HW_PWR_VDDMEMCTRL 0x8004_4070

For VDDIO, you have to check the TRG bits in the HW_PWR_VDDIOCTRL register (0x8004_4060) and see what the voltage setting of the regulator is and check the DISABLE_FET bit, which disables the VDDIO DCDC converter.

Best regards.

Jorge.

Re: i.MX28 Linear Regulator Status

lategoodbye — Sat, 20 Sep 2014 12:22:46 GMT

Hi Jorge,

thanks for your reply. I'm not sure about your last sentence.

DISABLE_FET = 1 -> VDDIO disabled

DISABLE_FET = 0 -> VDDIO enabled

I'm i right?

BR Stefan

Re: i.MX28 Linear Regulator Status

igorpadykov — Tue, 23 Sep 2014 01:51:56 GMT

Hi Stefan

DISABLE_FET bit disables the VDDIO DCDC converter.

LinReg (note HW_POWER_VDDIOCTRL has not bit ENABLE_LINREG)

can not be disabled for VDDIO.

Best regards

igor

Re: i.MX28 Linear Regulator Status

lategoodbye — Tue, 23 Sep 2014 05:36:28 GMT

Hi igor,

so LinReg for VDDIO is always on?

Best regards

Stefan

Re: i.MX28 Linear Regulator Status

igorpadykov — Tue, 23 Sep 2014 09:59:49 GMT

yes

~igor

Re: i.MX28 Linear Regulator Status

lategoodbye — Thu, 16 Oct 2014 06:56:53 GMT

I've some more questions about this topic:

1. What is the expected state of the linear regulators after the imx-bootlets finished on a 5V power source only device?

2. Is it harmless to reduce CPU frequency in case the linear regulators are disabled?

3. What is the preferred method for detecting 5V power source within a linux driver (VBUSVALID0_STATUS, VDD5V_GT_VDDIO, IRQ or power status register)?

Re: i.MX28 Linear Regulator Status

igorpadykov — Thu, 16 Oct 2014 07:30:56 GMT

expected state of the linear regulators after the imx-bootlets

depends on particular board configuartion and this is fully programmable.

CPU frequency can be reduced in case the linear regulators are disabled.

Prefered VBUSVALID method as suggests AN4199

Re: i.MX28 Linear Regulator Status

lategoodbye — Thu, 16 Oct 2014 07:33:55 GMT

Thank you very much