Bridge spi-ethernet

silviagonzalez — Tue, 11 Nov 2014 13:25:20 GMT

Hello

I have installed bridge-utils-1.5, on i.MX287 and L2.6.35_10.12.01but I have encountered a problem with my bridge between spi and ethernet. I executed:

brctl addbr br0 &&

brctl addif br0 spi0 &&

brctl addif br0 eth0 &&

brctl setfd br0 0 &&

ifconfig br0 inet 192.168.1.2 &&

ifconfig br0 up &&

ifconfig eth0 up

, and the system said "brctl: bridge br0: Package not installed". Am I missing anything? Also, I have a driver that frames the data over Ethernet protocol, but,once the brige is set up, how do I send data via a network device? That is, how do I make the SPI device send data? Which device should I work with: spi0, br0, eth0 and how?

Re: Bridge spi-ethernet

jamesbone — Mon, 24 Nov 2014 14:06:22 GMT

Hello Silvia,

Please check the following link, give instructions on how to use the Brigde Utilities. which I think it is the problem :

http://www.linuxfoundation.org/collaborate/workgroups/networking/bridge

Have a great day,
Jaime

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

i.MX ProcessorsのトピックRe: Bridge spi-ethernet

Bridge spi-ethernet

Re: Bridge spi-ethernet