topic Re: stuck at starting kernel in i.MX Processors

stuck at starting kernel

srinivas_123 — Tue, 18 Jun 2024 17:09:56 GMT

i am using imx8mplus lpddr4 evk. and i build the yocto 6.1.55 BSP version

for custom board i changed the DRAM size to 1GB , and frequency to 2400MTS.

After booting up , it stuck at Starting Kernel . if anyone know why this is happening. where i did the mistake . please help me out.i attached boot log.

Regards ,

Srinivas

Re: stuck at starting kernel

Bio_TICFSL — Wed, 19 Jun 2024 14:26:45 GMT

Hello,

Apparently you don't have enough memory to boot the MX8MPlus, we suggest at least 2GB of RAM.

Regards

Re: stuck at starting kernel

srinivas_123 — Fri, 21 Jun 2024 05:44:49 GMT

@Bio_TICFSL

Thank you for your response. just confirm, I have read a few NXP forums. they suggest disabling some nodes(which are not required). so, I disabled HDMI, pCIe, and LVDS. after that, it moves ahead. and again kernel gets stuck and shows panic.

am I following the correct way or not?

I observed the SP/PC alignment exception in the log. Does this issue come because of less size of the memory.?

I have attached a log file. please check once.