i.MX6Quad Jumpstart Development Kit

vittoria98 — Thu, 08 Dec 2022 10:51:33 GMT

Good morning everyone,

I have the Connectcore 6 for i.MX6Quad Jumpstart development kit, and I'm trying to test its JTAG connections.

I've uploaded the netlist, BOM, schematic, and BSDL file. The board is connected to JTAG link2 through Tag-Connect’s TC2050-IDC-NL “No Legs” Plug-of-Nails™ cable and an ARM 20-pin to ARM 10-pin.

This is the error I get:

Starting Check Chain...

No valid data returned from the JTAG chain.
Perhaps the pin map is incorrect, or the board is not powered.

Check Chain failed

I believe there is a problem with the pin mapping/reset sequence, but I can't figure out what it is; can you help me with that?

Thank you,

Vittoria

Re: i.MX6Quad Jumpstart Development Kit

riteshmpatel — Fri, 09 Dec 2022 13:00:44 GMT

Hi @vittoria98 ,

I hope you are doing well.

Could you please check with the other JTAG device?

Thanks & Regards,
Ritesh M Patel

i.MX Processorsのトピックi.MX6Quad Jumpstart Development Kit

i.MX6Quad Jumpstart Development Kit

Re: i.MX6Quad Jumpstart Development Kit