topic Re: how to start serial console on imx53 linux? in i.MX Processors

how to start serial console on imx53 linux?

hiromitakano — Thu, 17 Jan 2013 08:17:39 GMT

Hello,

I'm using a custom board, based on the START-R board, and I can succesfully start u-boot and kernel 2.6.35 on it. I load uImage, u-boot and initramfs on an sd-card, I send the boot command and then I see the output from the kernel, until it arrives at the message "feed watchdog", which is written periodically on the output. I would expect a serial console, like the one given by the quick start board...

Please, could anybody help me to find out what I could have missed?

Re: how to start serial console on imx53 linux?

lily_zhang — Thu, 17 Jan 2013 11:43:24 GMT

You had better check your "console" setting into bootloader. And use the right console output.

Re: how to start serial console on imx53 linux?

hiromitakano — Mon, 21 Jan 2013 07:36:21 GMT

Do you mean the console environment variable in u-boot? I've set it at console=ttymxc1, i.e. UART2, and I'm sure it works, because other messages from the kernel are correctly sent to this serial interface (e.g. the "feed watchdog" one).

Re: how to start serial console on imx53 linux?

lily_zhang — Mon, 21 Jan 2013 07:52:35 GMT

So I guess you flash the ram rootfs for MFGTool instead of the normal rootfs for booting.

Please flash the right default rootfs.

Re: how to start serial console on imx53 linux?

hiromitakano — Mon, 21 Jan 2013 09:29:48 GMT

Thank you for your answer, after compiling and depoloying I load these files onto sd-card for booting:

ltib/rootfs/boot/u-boot.bin

ltib/rootfs/boot/uImage

ltib/initramfs.cpio.gz.uboot.

If the latter is not the right initramfs where should I find the right one?

Re: how to start serial console on imx53 linux?

lily_zhang — Mon, 21 Jan 2013 09:38:47 GMT

I assumed that you are using ltib. So you can input the following command line:

./ltib -m selectype

Select as the followings:

│ │ --- Choose the platform type │ │

│ │ Selection (imx5x) ---> │ │

│ │ --- Choose the packages profile │ │

│ │ Selection (FSL gnome release package) --->

If you just want to try a minimum rootfs, you can select “Minimum bootable root filesystem”.

Then “Save” it. You can see another prompt menu. Select as the followings:

│--- Target System Configuration │ │

│ │ Options --->

You can see the followings:

│(freescale) target hostname │ │

│ │[*] boot up with a tty and login │ │

│ │(::respawn:/sbin/getty -L ttymxc0 115200 vt100)