i.MX6sl (imx6slevk) and E-INK panel(ES103TC1)

jerechu — Mon, 24 Jun 2019 06:23:45 GMT

Hi all,

Here we use pre-build L4.9.88_2.0.0_images_MX6SLEVK.tar.gz as our boot-image, steps to setup/boot/test EPDC:

1.Download and decompress BSP pre-build image package .

2.Program the SD image on the SD card(8GB) with command(I'm running this in Ubuntu): "dd if=fsl-image-qt5- validation-imx-xwayland-imx6slevk.sdcard of=/dev/sdb;sync"

3. Insert SD card on i.MX6slevk board, connect debug-UART and power-on the board.

4. modify the u-boot environment variables as below:

a.) setenv fdt_file imx6slevk.dtb

b.) setenv mmcargs 'setenv bootargs console=${console},${baudrate} root=${mmcroot} epdc video=mxcepdcfb:ES103TC1,bpp=16'.

5. boot into Linux kernel, run unit-test: "/unit_tests/Display/mxc_epdc_fb_test.out", should be able to have test patterns running on EPD.

But we have a problem,Unable to open /dev/fb2.

Could somebody help me?

Re: i.MX6sl (imx6slevk) and E-INK panel(ES103TC1)

art — Fri, 28 Jun 2019 06:38:44 GMT

The pre-built image does not contain the EPDC support by default. You have to build the new image with enabled EPDC support.

For the general information on how to build and deploy the custom Linux image, please refer to attached i.MX Yocto Project User's Guide and i.MX Linux User's Guide documents. For the information on how to enable and configure the EPDC driver, please refer to the Section 6.2.6.1 "Electrophoretic Display Controller (EPDC)" of attached i.MX Linux Reference Manual document.

When configuring the driver, make sure that you have provided the correct .fw file to the driver.

Best Regards,

Artur

topic i.MX6sl (imx6slevk) and E-INK panel(ES103TC1) in i.MX Processors

i.MX6sl (imx6slevk) and E-INK panel(ES103TC1)

Re: i.MX6sl (imx6slevk) and E-INK panel(ES103TC1)