Problem with booting from eMMC. Can't write u-boot correctly

3dfxuser — Thu, 27 Jun 2019 16:46:11 GMT

Hello!

I've got a problem during getting eMMC boot work. I’ll say right away that this is definitely not the case of wrong fuses, GPIO settings or something else because everything worked fine until recently.

I followed this instruction, but system don't boot without any messages on UART. I think that this is related to the boot sector, since the control from the u-boot on SD card is successfully transferred to the system installed on the eMMC.

How can I get it work? Will be appreciate for every help.

Re: Problem with booting from eMMC. Can't write u-boot correctly

igorpadykov — Thu, 27 Jun 2019 23:28:05 GMT

Hi Alex

that link is third party resource developed and supported by solidrun,

one can post it on its forum: https://developer.solid-run.com/

NXP uses uuu tool for programming images

GitHub - NXPmicro/mfgtools: Freescale/NXP I.MX Chip image deploy tools.

Linux documentation
i.MX Software | NXP

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

i.MX Processors中的主题 Re: Problem with booting from eMMC. Can't write u-boot correctly

Problem with booting from eMMC. Can't write u-boot correctly

Re: Problem with booting from eMMC. Can't write u-boot correctly