i.MX ProcessorsのトピックRe: PHP support for IMX8MQ yocto

PHP support for IMX8MQ yocto

anumulamudi_sir — Wed, 15 May 2019 14:43:53 GMT

Hello nxp,

we are using imx8mq evk + yocto latest distribution 4.14.98

how to add php and lighttdp support

Regards,

sireesha

Re: PHP support for IMX8MQ yocto

Bio_TICFSL — Thu, 16 May 2019 14:30:37 GMT

Hello khyathi,

If this is to be done in the bitbake itself then,

1. Add only php-cgi to image.bb file.

2. Modify lighttpd.bb file for the below lines,

RDEPENDS_${PN} += " \

lighttpd-module-access \

lighttpd-module-accesslog \

lighttpd-module-indexfile \

lighttpd-module-dirlisting \

lighttpd-module-staticfile \

lighttpd-module-rewrite \ --added new

lighttpd-module-auth \ --added new

lighttpd-module-fastcgi \ --added new

3. Recompile image for lighttpd package. ---bitbake -c clean package

4.Now rebuild with bitbake image.

I’ve seen this question also in external forums, I hope that they can provide some guidance as there is no documentation for running php on the i.MX.

I’ve found the following thread in an external forum, perhaps it can help. Although I’m guessing maybe you already found it while searching on the web.

Install PHP via Yocto - Toradex Community

Regards

Re: PHP support for IMX8MQ yocto

anumulamudi_sir — Fri, 17 May 2019 05:47:31 GMT

I added these lines in lighttpd_1.4.48.bb file

RRECOMMENDS_${PN} = "lighttpd-module-access \
                     lighttpd-module-accesslog\
                        lighttpd-module-dirlisting
                        lighttpd-module-staticfile\
                        lighttpd-module-rewrite\
                        lighttpd-module-auth\
                        lighttpd-module-fastcgi"

while building i am getting this error

unparsed line: 'RRECOMMENDS_${PN} = "lighttpd-module-access lighttpd-module-accesslog lighttpd-module-dirlisting'