i.MX ProcessorsのトピックFailed to execute MI Command:

Failed to execute MI Command:

sortiz — Mon, 23 Jul 2018 21:46:30 GMT

I build and debug NXP examples fine on IMXRT 1050 dev board, if I disconnect the board every single time before debugging. Next I terminate debug mode, i change the code,build, and debug without disconnecting the board and get this error.

Thank you for your time,

Steven O.

Re: Failed to execute MI Command:

igorpadykov — Mon, 30 Jul 2018 08:51:41 GMT

Hi Steven

such error usually happens when previous debug session was not terminated propely,

one can check suggestions for this on:

GDB Debugging with Kinetis Design Studio

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Failed to execute MI Command:

sortiz — Thu, 10 Jan 2019 17:04:42 GMT

This document was very useful for debugging, yet I had the same error.
This update is for future people that may have the same problem. I had version v10.2.0_759.

I resolved the issue with installing a new MCUXpresso Verision- v10.2.1_795.

Thank you,