i.MX ProcessorsのトピックRe: MfgTool image downloading error

MfgTool image downloading error

xhlow — Fri, 09 Nov 2018 01:42:47 GMT

Hi All,

I just received a MCIMX6ULL-EVK this week. I tried to download image using MfgTool2 with L4.9.88_2.0.0 iMX6,7 BSP. But it show error message below when I downloading the image.

U-Boot 2017.03-imx_v2017.03_4.9.88_2.0.0_ga+gb76bb1b (May 01 2018 - 15:03:05 -05 00)

CPU: Freescale i.MX6ULL rev1.0 at 396 MHz
Reset cause: POR
Model: Freescale i.MX6 ULL DDR3 ARM2 Board
Board: MX6ULL 14X14 DDR3 ARM2
DRAM: 1 GiB
ERROR: read error from device: bef4a9a8 register: 0x0!
at /home/bamboo/build/4.9.X-2.X/fsl-imx-xwayland/temp_build_dir/build_fsl-imx-xw ayland/tmp/work/imx6ull14x14ddr3arm2-poky-linux-gnueabi/u-boot-imx/2017.03-r0/gi t/drivers/power/pmic/pfuze100.c:46/pfuze100_read()
Not supported, id=11
initcall sequence bffa8920 failed at call 878042d4 (err=-22)
### ERROR ### Please RESET the board ###

Kindly need your help on this?

Thanks.

Regards,

XH Low

Re: MfgTool image downloading error

igorpadykov — Fri, 09 Nov 2018 23:17:45 GMT

Hi XH Low

from log it is not MCIMX6ULL-EVK but "MX6ULL 14X14 DDR3 ARM2" and it has

different uboot image:

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: MfgTool image downloading error

xhlow — Mon, 12 Nov 2018 03:19:18 GMT

Hi Igor,

May I know where to get this u-boot image?

Thanks.

Regards,

XH Low

Re: MfgTool image downloading error

igorpadykov — Mon, 12 Nov 2018 07:52:41 GMT

Hi XH Low

please try

https://www.nxp.com/webapp/Download?colCode=L4.9.88_2.0.0_MX6UL7D&appType=license&location=null&Parent_nodeId=1337699481…

Best regards
igor

Re: MfgTool image downloading error

xhlow — Tue, 13 Nov 2018 08:23:06 GMT

Hi Igor,

We able to download the image. Just double click one of the desired .vbs script to run the mfgtool.

Thanks.

Regards,
XH Low