IMX6Q MfgTool burn program failed

tommyduan — Sat, 03 Nov 2018 12:55:24 GMT

We use Mfgtool burn program ,it stop"jumping to os image",can't going on!How can we find the reason?before it's ok,Where should I look for the reason？How does the burning process run?How does the system process work after startup?

Re: IMX6Q MfgTool burn program failed

igorpadykov — Sun, 04 Nov 2018 23:00:30 GMT

Hi tommy

stop"jumping to os image" may mean that board can not run mfg tool

since ddr settings are wrong for that board. It s necessary to run ddr test

i.MX6/7 DDR Stress Test Tool V2.92

https://community.nxp.com/docs/DOC-328258

and rebuild mfg tool with new ddr settings found from ddr test.

For example one can look on

How to build MFG Firmware for i.MX6Q

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

topic Re: IMX6Q MfgTool burn program failed in i.MX Processors

IMX6Q MfgTool burn program failed

Re: IMX6Q MfgTool burn program failed