topic How to test IMX7? in i.MX Processors

How to test IMX7?

imx7newbie — Wed, 31 Jan 2018 09:43:00 GMT

Hi,

I am very new to IMX7/Yocto Linux.

I got a board having IMX7 from Phytec

phyBOARD-Zeta (i.MX 7) - Develop.phytec - PHYTEC Wiki

and loaded the prebuilt Image and found following output on terminal(see attachment).

After linux booted, it comes following

"random: nonblocking pool is initialized".

What is this?

When I plug LAN cable it comes:

"fec 30be0000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx
IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready "

Actually I have no idea how to test IMX7? Any Idea?

I would like to use its PCIE interface for a project.

Re: How to test IMX7?

igorpadykov — Wed, 31 Jan 2018 10:23:09 GMT

one can follow nxp linux documentation found on

i.MX Software|NXP

FreeRTOS documentation on

i.MX 7Dual Arm Cortex-A7 Processor|NXP

and application notes on

i.MX 7Dual Arm Cortex-A7 Processor|NXP

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------