i.MX ProcessorsのトピックRe: Flashloader_RT1050_1.0 Application crashed on windows10

Flashloader_RT1050_1.0 Application crashed on windows10

xieyangly — Thu, 23 Nov 2017 02:01:33 GMT

step1 run the mfgTool2.exe

step2 insert the usb cable to computer,the zhe mfgtool2.exe crashed.

the sw7status：off on off on

use usb( j9) connect to computer

power by usb (j9)

Re: Flashloader_RT1050_1.0 Application crashed on windows10

Rita_Wang — Fri, 22 Dec 2017 07:56:37 GMT

Hi,

It maybe caused by the usb port. Here you can use the windows7 system on your PC, or you can try to use the USB HUB to connect your board to PC.

Have a nice day

Rita

Re: Flashloader_RT1050_1.0 Application crashed on windows10

xieyangly — Fri, 22 Dec 2017 08:45:09 GMT

it work on win7 very well。but crashed on win10 On 2017-12-22 15:57 , b45499 Wrote: NXP Community Re: Flashloader_RT1050_1.0 Application crashed on windows10 reply from Rita Wang in i.MX Community - View the full discussion Hi, Have you tried it on windows 7? It works well on my win7 PC. Have a nice day Rita Reply to this message by replying to this email, or go to the message on NXP Community Start a new discussion in i.MX Community by email or at NXP Community Following Re: Flashloader_RT1050_1.0 Application crashed on windows10 in these streams: Inbox This email was sent by NXP Community because you are a registered user. You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences

Re: Flashloader_RT1050_1.0 Application crashed on windows10

Rita_Wang — Mon, 25 Dec 2017 04:26:49 GMT

When you use the windows10, you can try to use the USB HUB to connect your board to PC.