i.MX ProcessorsのトピックRe: i.MX6 ZQ pull-down calibration.

i.MX6 ZQ pull-down calibration.

takayuki_ishii — Tue, 16 Jan 2018 02:39:33 GMT

Hello community,

I have a question about method of ZQ automatic pull-down calibration.

In ZQ automatic Pull-up calibration(section 44.11.2.1.1), it say that

"The MMDC drives zq_pu_pd_sel to "1"for indication of pull-up calibration"

From Figure 44-8 in Reference manual, It will connect between internal pull-up and external pull-down

In ZQ automatic Pull-down calibration(44.11.2.1.2), it say that

"The MMDC drives zq_pu_pd_sel to "0" for indication of pull-down calibration"

In Figure 44-8, it seems that detach internal pull-up register and attach internal pull-down register

to external register.

It seems that both internal and external register are pull-down so ZQPAD keep GND level.

So we think that in pull-down zq calibration, internal pull-up and internal pull-down register

will attached to the comparator and detach external register.

Is it correct understanding?

Best regards,

Ishii.

Re: i.MX6 ZQ pull-down calibration.

Yuri — Tue, 16 Jan 2018 08:00:51 GMT

Hello,

Generally You are right:

The internal pull-up resistor calibration is done using the 1% external resistor.

The internal pull-down resistor calibration is done versus the internal pull-up resistor.

Have a great day,
Yuri

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: i.MX6 ZQ pull-down calibration.

takayuki_ishii — Tue, 16 Jan 2018 08:04:00 GMT

Hello Yuri,

Thank you for your quick response.

I will answer it to my customer.

Best regards,

Ishii.