IMX6 eMMC Partitions

venkatachilakal — Thu, 17 Aug 2017 13:05:27 GMT

Hello,

I am working on IMX6Q Board which is similar to sabre-sd. On this board we have eMMC ( 4G ).

For board testing i have partitioned the eMMC with two partitions boot and rootfs.

I have loaded the dtb file and zImage in boot partition and file system in rootfs partition.

Once I powered up the board. i just load the u-boot.imx using imx_usb_loader.

This u boot loads the kernel and it working fine.

But, I would like to store the u-boot also in the eMMC and u-boot must load on power up.

Please do point me to make this happen.

Re: IMX6 eMMC Partitions

igorpadykov — Thu, 17 Aug 2017 23:00:58 GMT

Hi Venkata

please refer to sect.4.4.1.2 Using eMMC attached Linux Guide. Also one can

use mfg tools from link

http://www.nxp.com/products/software-and-tools/software-development-tools/i.mx-software-and-tools/i.mx-6series-i.mx-7series-software-and-development-tool-resources:IMX_SW

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

i.MX Processors中的主题 Re: IMX6 eMMC Partitions

IMX6 eMMC Partitions

Re: IMX6 eMMC Partitions