CodeWarrior for MCUのトピックRe: L4025: This limited version only allows 1024 bytes of code

L4025: This limited version only allows 1024 bytes of code

dwilks — Thu, 13 Mar 2008 01:12:23 GMT

I'm using CW 5.7.0 build 2211. CW Dev Studio for HCS12(X) v 4.6 build 6346.

Yesterday I was in the office, I successfully built my project, downloaded it, and debugged it. I left CW running. Today I'm at home, attached to my work computer over remote desktop. I make one change to a source file (serial port baud rate divisor, so no major change to the project), built and receive "L4025: This limited version only allows 1024 bytes of code."

I know that I can't start CW while attached via Remote Desktop but did I just run into another limitation?

Thanks

Re: L4025: This limited version only allows 1024 bytes of code

CompilerGuru — Thu, 13 Mar 2008 10:27:58 GMT

Well, I would say you did run into the same limitation, ide checks its license when starting up, the linker when actually doing its job.

Daniel

Re: L4025: This limited version only allows 1024 bytes of code

CompilerGuru — Thu, 13 Mar 2008 10:38:10 GMT

see also this (old) thread.

http://forums.freescale.com/freescale/board/message?board.id=CW816COMM&message.id=107

But I fear that Albans tip does not completely work for 8/16 bit, as you remarked.

Daniel

Re: L4025: This limited version only allows 1024 bytes of code

CrasyCat — Thu, 13 Mar 2008 19:43:27 GMT

Hello

If you wan to work through remote desktop you need a special license file with TS_OK in there.

I would recommend you to submit a service request to our licensing team for that.

Click here to submit a service request.

Specify Category : Technical Request

Topic : License Issues

Attach your current license.dat file to the service request.

CrasyCat