CodeWarrior for MCU中的主题 default window settings

default window settings

e_taylor — Thu, 08 Nov 2007 07:45:34 GMT

hello:

cw newbe question:

i am using cw4.6 for assembler project development. i always want my data window to be in hex format and the mode periodical. is there a preferences setting for this?

thanks in advance!

regards,

Re: default window settings

BlackNight — Thu, 08 Nov 2007 16:49:37 GMT

Hello,
typically, the settings are stored in the debugger .ini file (typically project.ini).
You may simply run the debugger, do your modifications and then use the menu File > Save Configuration which then shall store the settings in the current configuration file used.

BK

Re: default window settings

e_taylor — Fri, 09 Nov 2007 03:21:15 GMT

hi BlackNight:

thanks very much. i spent quite a while trying to find some complicated way to do this.

best regards,

Re: default window settings

CrasyCat — Mon, 12 Nov 2007 23:22:48 GMT

Hello

I assume you are speaking about global data window. Am I right?

You can configure the Data window only after the application code is loaded to the target.

If your global data window is called "Data:1", you need to add an attributes command for Data:1 in the postload command file.

You can retrieve the postload command file name as follows:

- Start the debugger

- Select "Multilink/Cyclone Pro" -> "Command Files" and look at content of the "Postload" tab.

The command you need to add in the postload command file is:

Data:1 < attributes FORMAT Hex,MODE periodical,UPDATERATE 10

Make sure to replace "Data:1" with the name displayed in the Data window title bar.

I hope it helps

CrasyCat

Re: default window settings

e_taylor — Tue, 13 Nov 2007 05:05:17 GMT

hi CrasyCat:

thanks for the response! i was sort of on that line of thinking, however the "save configuration" works great as suggested by mr night.

thanks again!

regards,

ed.