topic Re: Watchpoint settin on a MC9S12NE64 using in CodeWarrior for MCU

Watchpoint settin on a MC9S12NE64 using

AaronP — Thu, 17 May 2007 20:58:51 GMT

HI,

I'm trying to set a watch point on a MC9S12NE64 using V6.1 of the true time simulator with a P&E USB MULITLINK pod. I disable all break points and set a watchpoing from the control points configuration window. I hit the OK button and then go back into the control points window and there are no watchpoints set. Can you set a watch point for this processor? If so How do you do it?

Thank you for your help.

-AaronP

Re: Watchpoint settin on a MC9S12NE64 using

CrasyCat — Wed, 30 May 2007 17:42:46 GMT

Hello

What are you trying to achieve here?

Where do you want to set your watchpoint?

Which steps are you performing to get it set?

Can you please be more specific?

Finally which version of CodeWarrior are you using?

To retrieve that info:
    - Start CodeWarrior
    - Select Help -> About Freescale CodeWarrior
    - Click on "Install Products"
    - CodeWarrior version used is displayed on top in the Installed Products dialog.

CrasyCat