topic Re: Could not open memory configuration file in CodeWarrior for MCU

Could not open memory configuration file

juliancox — Thu, 06 Jul 2017 11:00:44 GMT

I have just changed my hardware environment from DEMOQE to a USBDM connected to my S08SH target board. I have changed the debug configuration to USBDM, but when I launch DEBUG I get the message

"Could not open memory configuration file".

When I investigate the target properties I find "The path is not valid in all configurations" and "File is invalid"

What can I do about it?

Re: Could not open memory configuration file

Carlos_Mendoza — Tue, 11 Jul 2017 15:07:26 GMT

Hi Julian,

Could you tell us which CodeWarrior version are you using?

Thanks in advance!

Best Regards,
Carlos Mendoza
Technical Support Engineer

Re: Could not open memory configuration file

juliancox — Wed, 12 Jul 2017 10:04:22 GMT

10.7

Re: Could not open memory configuration file

Carlos_Mendoza — Wed, 12 Jul 2017 20:26:16 GMT

Hi Julian,

I believe it would be better if you create a new project for the S08SH MCU and develop based on this project. When you create a new project the Initialization and Memory files needed by the debugger will be added to your project inside the Debugger folder:

Once you have them you can use these files for your new USBDM connection following this steps:

Hope it helps!

Best Regards,
Carlos Mendoza
Technical Support Engineer