topic Re: Processor Expert CW10.6 Error Message on MKE06Z ConsoleIO in CodeWarrior for MCU

Processor Expert CW10.6 Error Message on MKE06Z ConsoleIO

eyeow84 — Fri, 25 Nov 2016 10:36:57 GMT

I am currently using FRDM-KE06Z (MKE06Z128VLK4) with CW 10.6. I am trying to use the Processor Expert (PE) to configure and generate code for the console for communication with my PC hyperterminal. Before that I was utilizing the sample codes from FRDM-KEXX Driver Library Package and the communication at hyperterminal works fine. And I understand that those sample codes is not generated from Processor Expert.

After I have setup the bareboard project folder based on target MCU MKE06Z128VLK4, next I wanted to go to component library of PE to select consoleIO and configure it. However error message below shown out:

Error: Error in the inherited component settings

It seems like I wasn't allowed to further configure this consoleIO. May I know why is this happening? or did I miss out something?

Thanks.

Re: Processor Expert CW10.6 Error Message on MKE06Z ConsoleIO

Alice_Yang — Mon, 28 Nov 2016 04:10:35 GMT

Hello Eyoew,

Please configure the Serial_ LDD component refer to your board, which UART, baud rate and other conifugrations:

Hope it hepls

Have a great day,
Alice Yang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Processor Expert CW10.6 Error Message on MKE06Z ConsoleIO

eyeow84 — Tue, 29 Nov 2016 07:25:32 GMT

Hi Alice,

Thanks for your advice. I think the error message has gone and PE code can be generated. But whether do you why I cannot specifically configure 115200 baud rate? Thanks...